SUN MACHINERY CORP

Telephone:  (516) 536 7375                    Fax:  (516) 536 7317

These rigs are located at various locations through out the USA and  Internationally.

e-mail:   rigs@sunmachinery.com

Cooper

 

 

COOPER LTO 550 (Ref#9017N)

Manufactured 2006

500 hp drawworks

104’ x 250,000# hydraulically raised mast on six lines

Double drum, hydromatic brake

42 x 12 main drum

42 x 8 sand drum with 16,000’ sand line right angle gearbox

Detroit series 60 diesel 500hp

AVTEC CLT754 automatic transmission

Mounted on 5 axle Crane with 4 hydraulic leveling jacks

Walkways and handrails

100 ton blocks

Price without tools:  $525,000

Item Description

Quantity

Swabbing Tools, Sinker Bar, Jars, etc

1set

HYDRAULIC OIL SAVER-Double  Rubber w/pump and hose, and 30’ lubricator

1

BJ ROD TONG

1

2 7/8 TUBING ELEVATORS

1

2 3/8 TUBING ELEVATORS

1

3.5 TUBING ELEVATORS

1

ROD TRANSFERS 1”, 7/8” TO ¾”

3

BJ TUBING TONGS WITH MANUAL BACKUP

1

1” ROD ELEVATORS

2

7/8” ¾” ROD ELEVATORS

2

1” ROD WRENCH

2

7/8 AND ¾ ROD WRENCH

2

FIRE EXTINGUISHERS

4

ROD HOOK

1

18” PIPE WRENCH (METAL)

2

36” PIPE WRENCH (ALUMINUM)

2

24” PIPE WRENCH (Metal)

3

24” ALUMINUM PIPE WRENCH

1

12” METAL PIPE WRENCH

2

HAND WRENCHES 3/8 TO 1 ¼ “

1

Price with tools: $680,000

 

 

 

COOPER LTO-550 (Ref#703N)

DRAWWORKS

CARRIER

ENGINE/ TRANSMISSION

DERRICK: Dragon Mfg. Spec API 4F (type)

Price: $675,000

 

 

COOPER LTO-550 SWAB RIG  (Ref#504N)  Manufactured 1980, Refurbished 2005, Cooper LTO-550 sand drum, mounted on 3 axle carrier with 6V71 Detroit diesel engine, 750 Allison transmission, leveling jacks, 16,000’ of 9/16” sandline, 45’ mast, 2 axle doghouse, completely tooled out, sotred inside  OFF MARKET

 

COOPER 550 (Ref#95N) Manufactured 1982, Cat engine, hydromatic, fully tooled  Price on request

 

COOPER WORKOVER RIG LTO 350 (Ref#8030N)  Manufactured 1979, Double drum drawworks, 104’ x 225,000# hydraulically raised mast, 42 x 10 main drum, 42 x 8 sand line drum, Disc Assist Brake, Mounted on 4 axle carrier with rebuilt 8V71, Detroit diesel engine, 750 Allison Transmission, Braden winch, Tubing Board, Rod basket, Work platform

TOOLS:  100 TON 3 Sheave Sowa Block, 1 ¾” x 72” Bales, (1) 2-7/8” Tubing Elevator, (1) 2-3/8” tubing elevator, (1) Set Cavins B Type Slips, All handling tools: Hammer Wrenches, Pipe Wrenches, All Swabbing Equipment

Price: $725,000

 

COOPER 350 WORKOVER RIG  (Ref#15367)  Manufactured 1981, Refurbished 1997, Double drum, 2” x 12” main drum, 38” x 8” sandline drum, Mast 97’ x 225,000# with 8 lines, hydraulically raised mast, Mounted on 4 axle carrier powered by diesel engine, hydraulic leveling jacks, Explosion proof lighting, 4 bottle (11 gallon each) closing unit, 10” double ram Shaffer BOP, 10” Hydrill annular BOP,

National 400 hp triplex mud pumps w/Detroit 6 cylinder engine, Cickson line with loop and swivels, 250 bbl mud mixing tank with hopper and precharge pump, 60kw generator with house, Mechanical workshop, Rig matting 20’ (2), Located Middle East    Price:  $650,000

 

COOPER LTO-350  (Ref#11312N)  Double drum, 55’ single piece mast, mounted on 4 axle carrier with diesel engine, 12-1/2” rotary table, 7 x 12” duplex mud pump, kelly, swivel, block  Price:  $370,000

 

COOPER LTO-350  (Ref#11016)  Manufactured 1977, double drum, 96’ x 200,000# mast, mounted on 4 axle carrier w/8V71 Detroit, 750 Allison transmission, 17-1/2” rotary table, hook/block, 7 x 14” Gardner Denver duplex mud pump, no engine  Price:  $500,000

 

COOPER LTO-150 DOUBLE DRUM SERVICE RIG  (Ref#442Nc)  Manufactured 1984, 38” x 10” tubing drum, 38” x 8” sand drum, 71’ x 150,000# Cooper derrick hydraulically raised and scoped, powered by 3306 Cat Turbo engine, 4 hydraulic leveling jacks, 754 Allison transmission, hydraulic winch, work floor/platform, 10,000’ +/- 5/8” sand line, 7/8” casing line, 75 ton casing block, bails, tubing elevators 1-1/2”, 2-3/8”, Guiberson T60 air slips 1-1/2”, 2-3/8” and 2-7/8”, rod hook, rod elevators 5/8” and ¾”, rod wrenches 5/8” and ¾”, Foster 5893-R power tongs 1-1/2”, 2-3/8”, 2-7/8” and 4-1/2”, swab tools 1-1/2”, 2-3/8”, and 4-1/2”, oil saver, pump, Martin Decker weight indicator, Cavin depth meter, Midco sand pump, wrenches, misc tools, 5 x 8 Gardner Denver mud pump with 671 Detroit diesel and 5 spd manual transmission, trailer mount HS60 Cooper Hydro sub with King 53GA swivel  Price:  $450,000

 

COOPER 32 X 32 DOUBLE DRUM  (Ref#600N)  Manufactured 1982, 671 Detroit diesel engine, rebuilt Allison 750 transmission, Cooper 4-axle carrier, Cooper 250 hp right angle box, 22 gallon 2-bottle accumulator with 2 valves for BOPS, Ramsey hydraulic winch, crown saver/protector for 71’ x 125,000# Poole stiff mast, hydraulic raise with 4 hydraulic jacks, outriggers, 2” 3000 mud standpipe, controls set up for power swivel, good tires, new cab, 7000’ 9/16” sandline, primed and painted blue and white, Canadian rig, shopped and repaired 2009.

REPAIR REPORT- 1982 COOPER 32 X 32

·      (2) new batteries

·      Replace air filter, (2) fuel filters, oil filters, transmission filter, 5 gallons engine oil, 10 gallons transmission fluid, 10 gallons 90 WT grease, 55 gallons diesel fuel

·      check valve

·      clean rig, power wash

·      Pressure test engine 671 Detroit, New alternator

·      (2) V belt, pressure test radiator- tested components

·      Replace metal on Carrier-Welder

·      Cut off fenders, New floor plate

·      (2) Cams for tubing brake

·      Replace halogen headlights, Drive line, U- Joint, Balance

·      Replace air lines

·      Install New Cab and wiring

·      Repair and test air system and hydraulic system

·      Built- New Catwalk and steps and hand grab rails

·      Drawworks- Replace pillow block bearings and brake line

·      Install Grease Lines for Drawworks

·      Chain and cover, handle for sand drum, clutch

·      Check Air controls

·      Repair- Hydraulic raising cylinder- Hydraulic Repair, Inc. Tulsa, Ok.

·      Put new cable on derrick with (4) new thimbles

·      (4) 8 ton rail boards

·      Remount tires, replace wheel studs

·      New derrick pins

·      Run cables for tubing and rod board

·      Complete paint job on rig. Preparation, Prime and Paint

·      Blast, Prime, Paint Derrick-Custom Slack and Truck Painting LLC, Cushing, Ok

Cooper 32 x 32- dimensions:  40’ front bumper to 1st axle, 95” front bumper to 2nd axle, 25’ 4” front bumper to 3rd axle,                                    29’ 2” front bumper to 4th axle, Mast/Derrick 65’L x 9’ 8” width Height 4’, Total weight 58,000#,  Road Dimensions-9’8” wide, 12’ 8” high, 40’ Carrier 48,000# 20’ 8” derrick overhang

·      671 Detroit- Excellent Condition

·      Allison 750 automatic transmission rebuilt- Precision, Canada

·      Wind load 54 MPH- guy wires recommended by manufacture

·      Rig has power tong circuit, Power swivel set up

   Excellent condition, located Oklahoma 

Price:  $210,000  PRICE REDUCED:  $185,000

 

COOPER 32 (Ref#6588N) single drum, 8 x 10 pole, Detroit diesel deck engine, mounted on truck that needs to be replaced, Foster 58 tongs  Price:  $70,000

 

COOPER T-32 WORKOVER RIG (Ref#66N)  Manufactured 1970, Double drum, 69’ x 120,000 still mast, Mounted on 4 axle Carrier powered by 6V92T Detroit (new engine) & TG6-27 transmission, Leveling jacks, Class 2 system, BOP ram saver & crown saver, Dual winches, Spent an excess of $200,000 on reworking, Handling tools, tubing, rods and power tongs, Excellent condition, 2 year left on level 4 certs   Price: $400,000

 

COOPER 32 X 32 DOUBLE DRUM SERVICE RIG  (Ref#442Na)  mounted on 1993 Mack truck with Mack E7 350 engine, right angle gear box, 8” x 7” x 65’ double poles hydraulically raised and scoped, hydraulic winch, 4 hydraulic leveling jacks 6500’ +/- 5/8” sand line, air clutch, 7/8” casing line, air clutch, 35 ton McKissick casing blocks, Foster power tongs 1-1/2”, 2-3/8”, 2-7/8” tubing bail, tubing elevators 1-1/2” and 2-3/8” Guiberson T40 air slips, rod hook, rod elevators 5/8” and ¾”, wrenches, swab tools, 1-1/2”, 2-3/8” and 4-1/2”, oil saver, pump, Martin Decker weight indicator, depth meter, Midco sand pump, misc tools  Price:  $250,000

 

COOPER 32 SINGLE DOUBLE WORKOVER RIG  (Ref#1557Nh)  mounted on 1981 Ford single axle truck with Cat 3208, 5 speed trans., Detroit 353 deck engine, 8 speed trans., Cooper 32 single drum drawworks, 7 x 8 pole, leveling jacks  Price:  $55,000

 

COOPER 26/26 DD WORKOVER RIG  (Ref#11848)  Double drum, no line (capacity 420’ of 7/8” on main drum, 5900’ of 9/16 sandline),  69’ x 110,000# 4-leg mast, mounted on 3 axle  Crane Carrier with 8V71 Detroit diesel engine, Allison MT-654 transmission, 2 hydraulic leveling jacks, air clutch, 1 tubing block with hook, clean condition, new paint  Price:  $105,000

 

COOPER DOUBLE DRUM WORKOVER RIG  (Ref#1557Ne)  mounted on 1996 Ford truck, low mileage, Cummins engine, 8 speed transmission, 26 x 26 Cooper air over dog clutch, all air controlled, 366 International diesel with Allison auto on deck, 8 x 10 pole, leveling jacks, 2000’ 9/16” new sandline  Price:  $100,000

 

COOPER DOUBLE DRUM WORKOVER RIG  (Ref#1557Nj)  mounted on 1991 Ford truck, 9 speed trans., 453 Detroit deck engine, 5 speed trans., 32x6 Double Drum drawworks, air over dog clutch, 8 x 10 pole, leveling jacks  Price:  $145,000

 

COOPER A-126 WORKOVER RIG (Ref#345Nd)  Single drum with 50’ scoping derrick, Mounted on International truck w/ DT466 diesel, 5 speed transmission   Price:  $125,000

 

COOPER TR38  (Ref#13033a)  mounted on truck with burnt up front end, single drum, Detroit 6V53 diesel engine, 40’ mast  Price:  $32,000

 

COOPER SWAB RIG  (Ref#3165N)  mounted on 1998 GMC 8500 4x4 truck, Cat 3116 with 88,000 miles, 5 speed Allison automatic transmission (push button), air brakes, locking rear differential, 30 gpm hydraulic ump, 15,000# front winch, Detroit 471 deck engine, Muncie SM420 4-speed transmission belt drive to drum, 4 hydraulic levelers, 35’ bean that has hydraulic scope and lift, 5000’ of ½” sandline currently on drum, can hold 7000’+ of ½”, 2-5/8” swab tools 4-1/2” and 3-1/2”, 1-1/2” swab tools 2-7/8”, 2-3/8”, 1-1-/2”, homemade bailers 2-3/8”, 4-1/2”, 7”, sand pumps 3-1/2”, 4-1/2”, bits 4-1/2” and 3-1/2”, 1-1/2” broach and multi tools (rabbit catcher), 1500 psi oil saver with hand pump, depthometer, have all well tops, elbows, nipples, 6’ blow line, etc  Price:  $95,000